Simple Tips to Correct Issues with Conveyor Belt Tracking 1

The most important part of maintaining a conveyor belt is tracking it. Though it is one of the most painful things to deal with, when it comes to huge conveyor belts, tracking a conveyor belt corrects a lot of issues. Generally, if the conveyor belt isn’t trained the right way or isn’t aligned the way it should be, it will not follow the path it was intended to track and hence, will cause disruptions in the normal system.

Conveyor Belt Tracking

Luckily, conveyor belt tracking is not always tough if we follow some steps. Here in this article, we will discuss some tips to correct some issues while doing conveyor belt tracking.

Inspect the Frame

Generally, it has been seen that if the conveyor belt is not leveled or not square, most of the inaccuracies occur concerning the track. Hence, if you encounter a problem with tracking, you first need to inspect the frame to see if it is level or square.

You can use a standard deck available at any store to check if the frame is level. The next step you need to do is, you need to measure the belt from one end to the other, and if you see that the measurements are not equal, you need to pull the frame using the square rods provided by the manufacturer back into its alignment.

Inspect the Pulleys

Most people tend to steer only the end pulley during maintenance or installation of conveyor belts. The same goes when someone wants to track the conveyor belt. Leading the end pulley that much will cause the belt to miss track.

Instead of always steering the end pulley to make the belt follow its original direction, you can alternatively adjust the idlers and the snub pulley, which is there on the underside of the belt, to make the belt follow the desired direction.

Inspect for Debris

Debris accumulated under the belt is a prevalent scenario for conveyor belts. Naturally, sticky tapes and debris from the material or load being transported with the help of conveyor belts will accumulate somewhere. Now, this debris builds up over time and sometimes can be responsible for the miss-tracking of the belt. Since this debris, if not cleaned, will raise the pulley, causing miss tracking.

Though it is of utmost importance to check the conveyor unit for mechanical issues, it is also important that you keep the team clean. Check for debris accumulated under the belt routinely, and ensure no accumulation.

Inspect for Curves

Generally, when the conveyor belt is installed in a factory, it is cut down to its required width. Now, if the belt has not been cut perfectly straight, it might develop a curve or an arc, which might further lead to the miss-tracking of the conveyor belt.

If you own a company or a warehouse and need a conveyor belt, Rainbow Precision Products might help you. With an extensive inventory of conveyor belts and other things, Rainbow Precision Products is a leading manufacturer of conveyor belts today. Call them to know more.